Xtend Communications

— LoRaWAN Antenna Guide · AU915

LoRaWAN 915MHz
Gateway Antenna Australia

Every LoRaWAN gateway deployed in Australia — Dragino, RAK Wireless, Milesight, Kerlink, Tektelic — uses either an N-Female or RP-SMA Female external antenna port. This guide covers the correct D&G antenna and cable assembly for every gateway model and deployment scenario on the AU915 band.

AU915

Frequency Band

N-Female / RP-SMA

Gateway Connectors

5–8 dBi

Recommended Gain (Rural)

IP67

Outdoor Rating

Gateway Connector Reference

Find your gateway below to confirm the antenna connector type and which D&G cable assembly fits.

Gateway ModelTypeConnectorD&G Fit
Dragino DLOS8NOutdoor IP67N-FemaleDirect — LMR N-Male pigtail
RAK7240 / RAK7289Outdoor IP67N-FemaleDirect — LMR N-Male pigtail
Milesight UG67Outdoor IP67N-FemaleDirect — LMR N-Male pigtail
Kerlink iStationOutdoor IP67N-FemaleDirect — LMR N-Male pigtail
Tektelic Kona MacroOutdoor IP67N-FemaleDirect — LMR N-Male pigtail
Dragino LPS8N / LIG16IndoorRP-SMA FemaleRP-SMA Male to N-Male pigtail
RAK7268 / RAK7268V2IndoorRP-SMA FemaleRP-SMA Male to N-Male pigtail
Seeed SenseCAP M2IndoorRP-SMA FemaleRP-SMA Male to N-Male pigtail
MultiTech MTCAPIndoorRP-SMA FemaleRP-SMA Male to N-Male pigtail
Tektelic Kona MicroIndoorRP-SMA FemaleRP-SMA Male to N-Male pigtail

Recommended D&G Products for LoRaWAN

All antennas cover the AU915 (915 MHz) and AS923 bands. Custom cable assemblies built to site specification.

DG900MB-HG — 5GNR Broadband Omni

Primary external antenna for all outdoor N-Female LoRaWAN gateways — Dragino DLOS8N, RAK7240/7289, Milesight UG67, Kerlink iStation, Tektelic Kona Macro. IP67 outdoor rated. Mast or wall mount. The 915 MHz AU915 band sits in the middle of the 700–3800 MHz coverage range.

Freq
700–3800 MHz (covers 915 MHz AU915)
Connector
N Female
Rating
IP67

DGY900-6 — Yagi Directional Antenna

For rural AU farms and remote sites where maximum range is needed in a specific direction. 6–11 dBi directional gain pointed toward the sensor cluster. Recommended for point-to-point gateway-to-repeater links and single-direction agricultural deployments. Mast clamp mount.

Freq
700–3800 MHz (covers 915 MHz AU915)
Connector
N Female
Rating
IP67

N-Male to N-Male Cable Assembly

For N-Female outdoor gateways (Dragino DLOS8N, RAK7240/7289, UG67, Kerlink). LMR200 for runs up to 5 m. LMR400 for runs 5–15 m from rooftop or mast to gateway. Specify connector and length — built to order from Penrith.

Freq
DC – 6 GHz
Connector
N-Male both ends, any length

RP-SMA Male to N-Male Pigtail

For indoor RP-SMA gateways (Dragino LPS8N/LIG16, RAK7268, SenseCAP M2, MultiTech MTCAP, Tektelic Kona Micro) connecting to D&G N-Female external antennas. 30 cm standard, custom lengths available.

Freq
DC – 6 GHz
Connector
RP-SMA Male → N Male, 30 cm

Common deployment scenarios

Rural AU farm — maximum range deployment

Australian farmland typically has flat terrain and sparse coverage. An outdoor gateway pole-mounted at 5–10 m height with an DG900MB-HG omni (5–8 dBi) achieves 5–15 km range under AU915 LoRaWAN spreading factors. For directional sensor clusters, the DGY900-6 Yagi extends range further still. LMR400 cable runs up to 15 m keep insertion loss within budget at 915 MHz.

Urban or suburban LoRaWAN network node

Dense urban environments need lower gain (3–5 dBi) to avoid overshooting nearby nodes. The DG900MB-HG at 3 dBi nominal provides the ideal beam pattern for gateway-to-node coverage in commercial or industrial precincts. Pole or rooftop parapet mount via N-Male cable assembly from the N-Female gateway port.

Indoor gateway with external antenna upgrade

Dragino LPS8N and RAK7268 are frequently deployed indoors for cost or convenience but suffer from building attenuation. An RP-SMA Male to N-Male pigtail + an DG900MB-HG mounted externally — on a wall bracket or through a cable gland — recovers the lost gain and dramatically extends coverage without replacing the gateway.

Smart water metering gateway infrastructure

Water utility gateways (Kerlink iStation, Tektelic Kona Macro) are carrier-grade outdoor units with N-Female antenna ports. A D&G DG900MB-HG replaces or supplements the supplied antenna for sites with obstructions or where the supplied 3 dBi fiberglass doesn't reach the required meter coverage radius. Custom LMR400 cable runs available for pit or underground enclosure mounts.

Why IoT integrators and network operators use D&G

AU915 tested and specified

All D&G antennas are individually tested across the AU915 band (902–928 MHz) before despatch. VSWR and gain verified at 915 MHz. Not a US or EU product rebranded for Australia — specified and tested for the Australian LoRaWAN frequency plan.

Every connector type stocked

Outdoor N-Female, indoor RP-SMA, SMA — D&G builds matching pigtails and cable assemblies for every gateway brand. One supplier for the antenna, the cable, and the adapters means one order, no compatibility guesswork.

Custom cable assemblies for any mounting

Mast-top antennas, through-wall penetrations, underground pit installs — any cable length in LMR200 or LMR400, any connector combination. Built here in Penrith NSW against your site specification.

Stocked in Penrith — same-day available

No import lead time for standard product. DG900MB-HG omnis, DGY900-6 Yagis, N-to-N cable assemblies, and RP-SMA pigtails are all available for same-day collection from Penrith or next-day shipping.

— Get a Quote

Procurement
Made Simple

Submit your requirements below. Our engineering team responds within 1 business day with pricing and lead times.

Why quote through Xtend?

D&G Antennas — OEM supplier to ADT, JCI, Cardtronics, and Elsema. Direct to your project.

Direct to the Manufacturer

D&G Antennas makes the product. Your quote goes to the source — not a distributor or call centre.

200–500 Units Is Our Normal

Strategic pricing at 50+ units. Volume orders are our standard business — we won't blink at your quantity.

Custom Assemblies to Spec

Non-catalogue cable runs, frequency-tuned antennas, custom connector types. Quoted against your system drawings.

1-Day Response

We supply ADT, JCI, and Cardtronics — we understand what a procurement deadline means. Response within 1 business day.

Bulk Tier Pricing

50+ Units

Strategic discount applies automatically at 50 units per line item. Account pricing available for ongoing procurement.

Response within 1 business day · or email directly